Neu High pressure hose 1,8m oxygen compatible up to 415bar with connections G1/4″ union nut

High-pressure hose 1,8m long Operating pressure up to 330bar, suitable for oxygen

Oxygen is a very special gas, not only because it is essential for our survival, but also because it reacts chemically with almost all other substances. This can happen slowly as oxidation (rusting) or very violently as an oxygen explosion.

Therefore, very special hoses are needed to transfer oxygen. When the pressure is 200 bar or 300 bar, the selection of oxygen hoses is not very large. The operational safety of oxygen filling and withdrawal systems with pressure-bearing oxygen hoses and the use of our oxygen hoses in these systems is the responsibility and testing of the operator and builder of the oxygen system. Special precautions must be taken against oxygen pressure surges, contamination by fats, oils, and dust, which can lead to ignition of the oxygen hose and the oxygen system by oxygen. This hose is conditionally oxygen-compatible (pressure, temperature, flow rate, pressure surges, and purity).

Technical data of the high-pressure hose/oxygen hose

• Hose length 1,8m
• Nominal width 6mm
• Permissible operating pressure at +20°C max. 330 bar
• Oxygen-compatible (conditional resistance), (pressure, temperature, flow rate, pressure surges, and purity)
• Construction: inner Polyamide 12, polyester braid, outer layer polyurethane
• Wear-resistant and flexible
• Lightweight
• Temperature resistant -60° C to +100° C (short-term up to +120° C)
• Connection on both sides G 1/4″ union nut with 60° sealing cone